SunStar SPS/A-Pattern Series - Page 95

95
A. Insert a floppy disk having system program that
you want to update into a USB flash drive drive.
B.
After pressing MODE key, press ENTER
k
ey.
※ Caution
If READY LED turns on or upper feed plate is
under, some keys are not available. It happened,
operate the keys after lifting the upper feed plate
or pressing ENTER keys.
C. Move to “2. Sys. Update”by using direction keys
, then press ENTER key.
D. You can see the screen like a figure on the right
side.
E. If you press any key, the system program will
be updated after reading a USB flash drive.
During updating, READY LED flicker.
※ Caution
During reading a floppy disk, do not take out the
floppy disk from a disk drive or do not turn off
the main power.
F. When update is finished, you can see the screen
like a figure on the right side. By rebooting
after turning off the power, the update on the
system program is completed.
<< Main Menu >>
0. Initialize
1. Parameter Set
2. Program
<< Initialize >>
2. Sys. UpDate
Insert System
USB...
Press Any Key
To Continue...
Updating......-
System Updated!
Power Off & On!
To Restart.....
4-7) System Program Update
It is used for the system program that handles electrically controlled pattern sewing machine to be
updated. Only professional A/S engineers allow to operate it.