To Next PageTo Next PageWhat to do if SunStar SWF/C-T1501 has trimmer return failure?
If your SunStar Sewing Machine experiences trimmer return failure, it could be due to a poor connection of the sensor, a bad circuit board, a bad sensor or sensor position, or a dirty area around the sensor. To address this, check the connection, change the circuit board, change the sensor, clean around the sensor, or adjust the location of the sensor unit.
What causes failure of upper thread holder solenoid in SunStar SWF/C-T1501?
Failure of the upper thread holder solenoid in your SunStar Sewing Machine can be caused by a short-circuit of a fuse (if all heads fail), a poor connection or quality of the solenoid, a bad connection, or a poor quality circuit board. To resolve this, check/change fuse F1, F2, F3 in the joint board, check/change the solenoid and its connection, check the connection, or change the thread detecting plate in the sub controller.
General| Brand | SunStar |
|---|---|
| Model | SWF/C-T1501 |
| Category | Sewing Machine |
| Language | English |
Instructions for safe delivery of the machine, including crane and forklift usage.
Guidelines for installing the machine correctly, covering environment and foundation.
Essential safety rules for operating the embroidery machine.
Procedures and precautions for machine repair by qualified engineers.
Recommended environmental conditions for machine setup including temperature and humidity.
Procedures for safe and correct electrical installation, including voltage requirements.
Steps to ensure the machine is properly leveled using adjusting bolts and a level gauge.
Instructions for assembling the machine's frame components.
Identifies operation box components and their functions.
Explanation of emergency and start/stop button functions.
How to use the emergency stop feature for immediate machine shutdown.
Procedures for upper thread setup and tension adjustment.
Procedures for bobbin setup and tension adjustment.
How to control and adjust needle and hook timing for optimal stitching.
Step-by-step guide for installing the machine's operating system.
Detailed guide on using the machine's function menus.
Troubleshooting errors related to the main shaft motor.
Troubleshooting errors for X and Y axis motors.
Procedure for replacing fuses in the joint board for machines with <12 heads.
Fuse specifications for SWF/ -U Series machines.
Fuse specifications for SWF/C-UH 1508-45 machines.
Procedure for replacing fuses in machines with >12 heads.
Optimal voltage settings for X, Y drivers per machine model.
Key items to check during routine machine inspections.
Recommended procedures for cleaning machine parts.
Guidelines for oiling various machine components.
How to inspect and adjust drive belt tension.
Common operational failures and their solutions.
Diagnosing and fixing poor embroidery stitch quality.
Common causes and remedies for thread breakage.
Troubleshooting problems related to stitch tension.
Identifying and resolving causes of needle breakage.
