Questions? Call or Text +1-801-658-0015 • 1
e Micro Welder Experts
Welder Setup & Assembly
What is in the Box
(1) Orion PJ Welder/Power Supply and Stylus Hand Piece
(1) Orion PJ Welder Power Cord (2 pieces)
(2) Alligator Clips
(1) Shielding Gas Hose
(1) Fiberglass Brush
If You Purchased the Darkening Lens System:
(1) Darkening Lens System (lens and stand) with attached RJ45 Cable
If You Purchased the Microscope System:
(1) Orion Microscope Arm
(1) Microscope Arm Table Mount
How to Connect the Basic Cables
The Orion PJ cable connections vary. If you purchased the darkening lens or the microscope, cabling needs
change slightly. The darkening lens or microscope will automatically darken when the weld takes place, which
process. Reference Figure 2.1 on the next page and follow these instructions for easy setup:
•
• Plug the female end of the power cable into the AC Power port (A) on the back of the power supply.
Then connect the male end into an AC power supply. The Orion PJ has an internal switching power
supply that can accept both 120 and 240VAC.
•
connected, but should not come out if pulled on.
To Next Page
Loading...
