97
cause damages to compressor.
Bubbles indicate low cooling medium level, please contact
SUNWARD distributor to add cooling medium.
Inspection during idle seasons
If the air conditioning system is kept inactive for a long
time, perform a operation on cooler for 3-5 minutes every
month to lubricate each part of the compressor.
5.5.3.6 Check washer fluid level
Check reservoir for fluid level, add fluid if necessary.
When adding fluid, pay attention not to allow any dusts to
get in.
Mixture ratio of pure washer fluid and water
The mixture ratio differs according to the ambient
temperature. So dilute the washer fluid with water following
the table below.
Note: Pure detergent are divided into 2 categories： -10°C
（14°F ）(general use) and -30°C （-22°F ）(cold area use). Select
according to the area and season.
5.5.3.7 Adjust Bucket Clearance
Warning
When adjusting, it‘s dangerous if work equipment is
moved by mishandling.
Set work equipment at stable state, shut engine and lock
up safety lock lever.
Set work equipment in posture as shown in right fig.
Stop engine, set safety lock lever to LOCK position.
Remove O-ring of link to measure clearance ―a‖.
Note：
Move bucket to one side, or measure overall clearance at
Pure
detergent1/3：
water 2/3
Pure detergent
1/2： water 1/2
To Next Page
Loading...
