Sunwave Tech. SRC-3000b

Questions and Answers

R
robert85Jul 30, 2025
What to do if Sunwave Tech. Remote Control SRC-3000b doesn’t operate a device?
- S
  Sean BautistaJul 31, 2025
  If your Sunwave Tech. Remote Control (SRC-3000b) doesn't operate a device, ensure the desired device key on the LCD panel is selected. Move closer to the device, keeping in mind that the maximum operating distance is approximately 30 feet. Also, make sure that you are aiming the remote directly at the device without any obstructions. Verify the programming with the learning function or the manufacturer codes has been properly completed. You might also need to learn code the key.
A
april89Aug 7, 2025
What to do if Sunwave Tech. Remote Control displays “ERROR” during operation?
- J
  Jonathan LawsonAug 7, 2025
  If you see “ERROR” displayed on your Sunwave Tech. Remote Control during operation, it means that the key you pressed has not been taught. You should teach the key using the learning procedure.
M
Michael MartinezAug 14, 2025
What to do if I cannot operate a device even after using the Learning Function on Sunwave Tech. Remote Control?
- D
  danielstewartAug 14, 2025
  If you cannot operate a device with your Sunwave Tech. Remote Control even after using the Learning Function, ensure that your SRC 3000 has correctly learned the target device’s remote control code. You may also need to delete the device data from the SRC-3000b and carry out the learning function again. Also, ensure that you have not programmed more than one remote for a given device.
C
Cheryl HallAug 21, 2025
How to fix Sunwave Tech. Remote Control when LCD does not show anything?
- N
  Nathaniel CarrollAug 21, 2025
  If the LCD on your Sunwave Tech. Remote Control does not show anything when you touch it, replace the batteries with three new AAA alkaline batteries.