27
Chapter 4 Miscellaneous Settings
This chapter will tell you how to use transmission function,
setup the backlight, and adjust the beep.
4.1 Using the Transmission Function
The SRC-3000b can transmit customized data to another
SRC-3000b.
NOTE:
Before using this function to transfer data, you must
connect two SRC-3000b with SLC-2080 USB cable (optional
accessory). You can refer to Appendix B for more
information about the cable.
1. Press and hold for 3
seconds to enter the
confirmation screen. You
only need to operate on the
programmed SRC-3000b.
2. Press each number button
(2, 4, 6, 8) in any order until
they disappear and start to
use the function.
3. Press
and to select the
icon
. And then press
to begin the
transmission.
4. During the transmission, the
LCD displays blank keys as
shown in the illustration on
the next page.
To Next Page
Loading...
