32
Chapter 5 Controlling Devices
The SRC-3000b is designed to be simple and straightforward
to operate. This chapter explains how to use the SRC-3000b
to control all your devices.
NOTE:
This chapter assumes you have already set up the SRC-
3000b and saved all the IR codes for the keys. You can
refer to Chapter 3 Setting Up the SRC-3000b on page 9
for more information about how to get the IR codes.
5.1 Alternating Between Screens
Press a device key to alternate between page 1 and
page 2.
5.2 Controlling Devices
1. Make sure the SRC-3000b is pointing to the target device.
2. Tapping the Touch Screen gently.
3. Select a device key and give remote commands as
usual.
If the icon
appears, it means that the pressed key
doesn’t have IR code.
NOTE:
The Record Key (Within VCR Device, page 1)
must be held down for two seconds. It is a
double-confirmation design to prevent users
from overwriting a tape accidentally
To Next Page
Loading...
