Learning codes
15
Learning codes
If your device is not in the list of preset codes,
you can use your existing IR remote control to
“teach” the SRC-1600. You can program all
buttons except for
and the DEVICE keys.
NOTE:
Not all codes can be learned. If the SRC-1600
cannot learn a code, three beeps are emitted.
1. Set both remotes on a flat surface with the
target device’s remote control pointed at the
SRC-1600’s learning eye, for about 5 ~10 cm
apart.
2. On the SRC-1600, press the device button of
the device you want to
program.
3. Press and hold
to enter
setup.
4. Press
.
5. On the SRC-1600, press the
button to indicate the key you
want to program. Including Touch screen
buttons and hard buttons. Touch screen
buttons flash when you select them. Press the
device button to switch between touch
screen pages.
To Next Page
Loading...
