Sunwave SRC-1600 - Learning function failure

Troubleshooting
31
Problem solution
The SRC-1600 cannot
operate a device after
learning a function.
*Check the SRC-1600 has
learned the function correctly.
(See P15)
*Delete the code and teach
the SRC-1600 again. (See P17,
P15)
*Check you used the correct
remote to teach the SRC-
1600.
*The SRC-1600 cannot learn all
codes. Some remote’s
frequency might out of the
learning range. You may not
be able to program the SRC-
1600 for some devices or
functions.
The SRC-1600 emits three
beeps when learning a
function.
*Check the remote is correctly
aimed at the SRC-1600’s
learning eye and you are
holding the remote’s button
until the function is learned.
*Check the remote’s IR
transmitter is 5 ~ 10 cm from
the SRC-1600’s learning eye.