What to do if Sunwave Remote Control won't operate a device?
If your Sunwave remote control isn't operating a device, make sure the correct DEVICE KEY is selected. Also, try moving closer to the device, ensuring there are no obstructions and that you're aiming directly at it. Finally, verify the programming with the learning function or manufacturer codes was done correctly.
How to fix unsuccessful IR learning on Sunwave Remote Control?
If the IR learning process is not successful on your Sunwave remote control, try the following: replace the batteries in both the remote and the target device's remote, keep the remotes 2-4 inches apart, and avoid using the learning function near an incandescent lamp. If the learning process completes without errors but you still can’t control your devices, repeat the learning procedure.
Why Sunwave SRC-3060 LCD does not display when touched?
If the LCD on your Sunwave remote control doesn't display when touched, the batteries may be dead. Replace them with three new AAA alkaline batteries. Also, check that the batteries are properly installed.
What to do if you cannot operate the target device even after teaching it using the learning function on Sunwave Remote Control?
If you can't operate the target device after using the learning function on your Sunwave remote control, ensure the unit has correctly learned the target device’s remote control code. You may also want to delete the device data from the unit and repeat the learning function. Make sure you haven't programmed more than one remote for a given device.
How to troubleshoot Sunwave SRC-3060 Remote Control macro that does not work?
If the macro function isn't working on your Sunwave remote control, ensure you are aiming the unit at the devices while the macro commands are being sent. It's possible the target device’s remote might not be compatible with the learning procedure. Also, the macro might not have been set up correctly, so repeat the macro set-up procedure.
How to program a key that performs multiple functions on Sunwave Remote Control?
If your existing remote has a key that performs two or more functions, teach the unit the different commands. The Sunwave remote control can only learn one command for each key.
Why does the LCD screen turn off on my Sunwave SRC-3060 Remote Control?
The LCD screen on your Sunwave remote control is preset to automatically switch off after 90 seconds. Simply tap the screen to turn it back on.
What to do if Sunwave SRC-3060 Remote Control VCR will not record?
As a safety feature, you must press on the unit for two seconds for your VCR to record using the Sunwave remote control.
Important guidelines for handling and using batteries safely and effectively.
Instructions for gentle handling and cleaning of the touchscreen to prevent damage.
Step-by-step guide on how to insert AAA batteries into the remote control.
Detailed example of how to record a sequence of commands for a single button press.
General| Brand | Sunwave |
|---|---|
| Model | SRC-3060 |
| Category | Remote Control |
| Language | English |
To Next Page
