System Disarm
Press [ User Code ]
☼ The LINE, BATT, AC, ARM1, ARM2 lights will blink once.
The ARM light will turn off. The ARM1 light will turn off.
System Disarm
Information:
• Disarming the alarm security system will deactivate all the burglary zones of the system.
• Enter the premises through a programmed delay zone and disarm the system before Entry time is over. If the
system is not disarmed by the end of the Entry time, an alarm will occur.
• During disarmed mode, any violated zones will not enable burglary alarm except 24-hour zone. The 24-hour
zones are active irrespective whether the system is under armed or disarmed status.
• Disarming the system also resets triggered siren and strobe light.
• Key-switch input is available on the control panel and can be used to toggle the system to Arm and Disarm
alternately.
• A previously armed system would not Disarm if an illegal User code is entered. You may have up to 20 tries of
continual key entry of the correct 4-digit code in sequence before the keypad goes into a lock-out period of 10
seconds.
Options to be programmed by Installer:
• Personal Open/Close report:
If anyone from User-6 to User-10 disarms, the system dials the first programmed telephone number to report
of the Disarm activity and which User code was used to the intended receiving party. Personal reporting
format must be enabled first.
• Entry Beep:
Keypad beeper will beep continuously for the duration of Entry time.
• Chime:
A beep to indicate a zone is opened during system Disarm state. This function is temporarily canceled
during Arm state.
Please consult your installer to enable the above option!
Copyright © 2008 AASMSB Co. No. 135844-U. All Rights Reserved 5
To Next Page