Supa Q Series - System Test

Walk-Test
☼ The LINE light will blink to indicate Walk-test mode.
The respective zone light will turn on to indicate the zone
is tested.
1) Enter [ ∗ ] + [ 5 ] + [ User Code ]
2) Trigger all used zones.
3) Press [ 1 ] to activate siren
[ 2 ] to activate strobe light
Press the same digit again to switch off respective alarm output.
4) Press [ ∗ ] to exit Walk-test mode
The LINE light will turn off to indicate exit from Walk-test mode.
Walk Test
Information:
• Walk-test allows all zones, siren and strobe to be tested for functionality. Perform Walk-test periodically to
ensure the system is in a working condition.
• Ensure all zones are closed and there is no one within the premises before conducting Walk-test.
• Walk-test mode is not allowed during system Arm.
System Test
Enter [ ∗ ] + [ 8 ] + [ User Code ]
LCD Keypad
“ Online” will show system is call out
LED Keypad
The LINE light turns on to indicate system dialler performing CMS reporting.
☼ The LINE light blinks to indicate system dialler performing Personal reporting.
Test
Information:
• System test sends a test report to CMS and Personal telephone number (whichever reporting mode is enabled).
• Please inform your installer to activate this function if you wish to perform this operation.
Copyright © 2008 AASMSB Co. No. 135844-U. All Rights Reserved 8
www.ealarm.com.my