Review Event Memory
Numbering display will indicate zone triggered ☼ The LINE light will blink to indicate Review mode.
The ZONE light will turn on to indicate any zone triggered.
☼ Blinking zone light indicates latest zone triggered.
Press [ ∗ ] + [ REVIEW ]
(If Quick Review is enabled)
Or
Press [ ∗ ] + [ REVIEW ] + [ User Code ]
(If Quick Review is disabled)
Press [ 0 ] to clear the event memory.
Press [ ∗ ] to exit Review mode.
The LINE light will turn off to indicate exit from Review mode.
♪ 3 beeps to indicate exit from Review mode.
Review
Information:
• In this mode, the keypad can display all faulted zones after an alarm condition had occurred. The zone faults will
remain in the system memory until it is cleared by entering digit ‘0’ or when the next arming occurs or after
system reset.
• You may not enter Review event mode via keypad if the system is in Arm state.
• The system cannot enter Review event memory mode while in other operation mode. Press [ ∗ ] + [ ∗ ] to exit
from other operation mode.
Copyright © 2008 AASMSB Co. No. 135844-U. All Rights Reserved 7
To Next Page
Loading...