SUPAIR XP2 - Page 21

21
Adjust the backrest angle by pulling or releasing the adjustment
strap – pulling the black strap will offset the backrest angle from the
vertical setting. The lumbar support can be modied by adjusting
trim #5.
Tighten the shoulder straps by pulling the nger loop down. Pull up
to release. The shoulder straps support, greatly helps the overall
comfort level which should be set precisely. The correct tension
between the side trims and the shoulder straps adjustments must
be found. When adopting a reclined ying posture, the shoulder
straps must enhance in-ight comfort by supporting the upper
back area.
Backrest tilt adjustment.
Shoulders straps adjustments.
tighten
loosen
A
B
C
This adjustment is important for acting directly on the ABS and the harness’s overall stability. The tighter the more
stable. The opposite is true while still enabling weight-shift steering.
To tighten the chest strap:
Place your left hand in front of and around the risers to grab the right self-locking carabiner.
With the left arm, reduce the space between the risers and pull the nger-loop with your right hand to tighten the
chest strap.
To loosen the chest strap:
Place your left hand in front of and pass the risers to grab the right self-locking Biner.
With the left arm, shorten the distance between the risers and pull the nger-loop in the opposite direction to loos-
en the chest strap.
Chest strap adjustment.
loosen
tighten