14
www.supercircuits.com
SECTION 3: SETUP MENU USAGE
DAY / NIGHT
• AUTO: This mode is set for color in a normal environment, but switches to B / W
mode when ambient illumination is low. To set up the switching time or speed for
AUTO mode.
— D g N LEVEL: Adjust the Start Night level. Range: 0 to 255 steps
— D g N DELAY: Adjust the Start Night Delay time. Options: 1 / 3 / 5 / 10 / 15 /
20 / 25 / 30 seconds.
— N g D LEVEL: Adjust the End Night level. Range: 0 to 255 steps
— N gD DELAY: Adjust the End Night Delay time. Options: 1 / 3 / 5 / 10 / 15 /
20 / 25 / 30 seconds.
• COLOR: The picture is always displayed in color.
• B / W: ON / OFF. When ON, the picture is always displayed in black and white.
— BURST: ON / OFF. Burst signal is o during B/W mode.
— IR SMART: ON / OFF. IR GAIN: 0 ~ 255 steps; HEIGHT: 0 ~ 8 steps;
WIDTH: 0 ~ 13 steps; LEFT/RIGHT: 0 ~ 7 steps; TOP/BOTTOM: 0 ~ 10 steps
— IR LEVEL: LOW / HIGH
• EXT: This mode is used to apply a lter to external signals.
NOTE
- When using a video auto-iris lens, automatic switching between Color and B/W may
not occur if the level is set too low.
- The AGC in the EXPOSURE menu is “OFF” when DAY / NIGHT menu is “AUTO”.
- If using IR illumination, install an Extra-low Dispersion Lens to improve camera focus.
- For IR models, the Day and Night menu contains only the “Auto” option.
To Next Page
Loading...
