16
www.supercircuits.com
SECTION 3: SETUP MENU USAGE
• MOTION: If you connect an alarm device to the camera, you can monitor activities
more eciently because a signal is generated by the camera whenever a motion is
detected. The motion detection signal is output through the MD OUT port.
— OFF: Deactivate the MOTION function.
— ON: Activate the MOTION function.
AREA SELECT: You can select up to 4 areas to monitor for motion.
AREA STATE: Determine whether to use the area selected.
HEIGHT: Adjust the height of the area.
WIDTH: Adjust the width of the area.
LEFT / RIGHT: Adjust position of the area left or right.
TOP/BOTTOM: Adjust position of the area up or down.
DEGREE: Range: 0 ~ 255 steps
VIEW: ON / OFF
• PRIVACY: ON / OFF. The Privacy feature allows you to hide an area of the screen.
— AREA SELECT: You can select up to 8 areas.
— AREA STATE: Determines whether to use the area selected.
— HEIGHT: Adjust the height of the area.
— WIDTH: Adjust the width of the area.
— LEFT / RIGHT: Adjust position of the area.
— TOP / BOTTOM: Adjust position of the area.
— COLOR: Determine area color. You can select 15 kinds of color.
• PARK. LINE: The Park Line feature can be useful when the camera is installed in
vehicles as a backup camera. Adjust as necessary. Parameters set the position of the
parking lines. See the diagram to the right.
To Next Page
Loading...
