SUPER73 Super73-S2 - PRE-RIDE SAFETY CHECK; WHEELS; BATTERY; BRAKES SYSTEM

7. KICKSTAND
 Make sure that the kickstand is tightly secured, and not rubbing against
the ground or tires.
3. BRAKES SYSTEM
 Pull both brake levers. You should feel an obvious pressure point and the
levers should not be able to touch the handle.
2. BATTERY
 Check that the battery is inserted securely: push the battery into its
holder until it clicks into the lock. Remove the key from the lock and
pull the battery to check if it has indeed locked into place.
 Check the charge status of the battery. Familiarize yourself with
battery charging and storage best practices.
More information on battery maintenance in our maintenance &
components section of this handbook on pg. 26.
PRE-RIDE SAFETY CHECK
Make sure the brakes have already been applied before getting on to your bike.
If the assistance mode is turned on, your Super73 will start moving as soon as
you push on the pedal. The unfamiliar push can otherwise cause a fall, hazard, or
accident.
DANGER!
Do NOT ride your Super73 if it has been assembled incorrectly. Riding an incorrectly
assembled bike can put your own safety at risk as well as others.
Never operate your bike and use your app simultaneously.
!
TIP
CHECKLIST:
. WHEELS
 Check the condition of both tires making sure the tread is in good
condition, free from punctures, cracks and deformations.
 Maintain proper tire pressure. We recommend a range of 27-30psi
(.86 - 2.06 bar) dependent on the weight of rider and type of terrain.
 Ensure wheels are true and properly dished.
 Make sure that the wheels are properly seated in the dropouts and
that the wheel nuts are tight and secure.
5. CABLES
 Look out for any loose cables.
 Make sure that every male and female plug is properly connected.
 There should be no strain on any wiring near the fork when turning the
handlebars from left to right.
 Verify that the wiring on the frame is secure and free from any moving
parts that may damage the wiring. This includes any wires and brake
cable lines near the wheel or other moving parts.
6. DISPLAY
 Check that your display turns on and functions properly.
14
More information on brakes in our Maintenance & Components section.
TIP
Do not sit on a bike while the kickstand is supporting the bike.
!
4. LIGHTING
 Check if the front and rear lights are working properly. Do not cover any
lighting or reflectors.