28
The battery is the most important component of your Super73. By following the best
practices below, you can optimize its life:
• Do not store a discharged battery. It could go into deep discharge which will
reduce its life. Batteries in deep discharge are not covered under warranty.
• Do not use more than one battery at a time.
• Make it a habit to recharge at the end of each ride, so your bike will always be
ready to go again.
• Even if the battery can withstand storage temperatures of 23°F - 04°F (-0°C -
40°C), you can optimize its shelf life by storing it at room temperature 65°-75°f
(8° - 23°C).
• Observe operating conditions between 40°F - 85°F (4°C - 30°C).
• Do not leave your battery exposed to high temperatures or direct sunlight for
long periods of time (for example, on the back of a car in direct sunlight).
• Please ensure that the contacts are always clean and do not insert metal objects.
• Do not dispose of the battery in your trash. There are proper disposal methods
for lithium-ion batteries. Please check your local waste management regulations.
!
!
1. Pads and pad holders are held in place by a 3mm pad retainer bolt on the caliper.
To remove the pads and pad holder, unscrew the retainer bolt, then gently push
out the pads and holder. This may be easier to achieve by using an Allen wrench.
2. Once free of the caliper, the pads may be easily removed from the pad holder.
Super73 brakes are from the Tektro brand. For any manufacturing problems or
questions related to Tektro brakes, you can contact the local Tektro representative.
The contact details of the distributors and places of services: http://www.tektro.com/
service-a.php?t=
Please follow proper charging instructions before charging the battery found on pg.
2. To charge the battery, use only the original charger or charger approved by the
manufacturer. Remove the battery from the charger and disconnect the charger from
the power supply when charging is complete.
Do not open the battery or charger. There is a risk of short circuit. Opening the
battery or charger will void the warranty. Protect the battery and charger against
mechanical damage, heat (in case of prolonged exposure to sunlight), fire, and
immersion in water. There is a risk of explosion. In case of damage and improper use
of the battery or charger, vapors may emanate. Keep children away from the battery
and charger.
BATTERY
TIP
REPLACING THE PADS
When pads are worn, make sure to adjust both clearances between the rotor and pad
so that they are equal and balanced. If only one side is adjusted, it may cause braking
failure.
Any time you replace your brake pads, rotors, or both, it is important they are
properly bedded for optimal performance. To bed your brakes properly after
replacement, accelerate your bike up to 20mph and then engage your brakes to bring
the bike to a near stop, then repeat the process up to 8-0 times. This process allows
your pads to wear evenly as well as remove surface glaze and contamination from
installation. Surface glaze on pads may cause “squealing brakes.”
NEW BRAKE PAD & ROTOR BED-IN PROCESS
THE TEKTRO WARRANTY
To Next Page
Loading...
