Page 9 of 24 Form 0157G 1805 10/02/2007
Superchips Inc.
Superchips Inc. 1790 East Airport Blvd., Sanford, FL. 32773 (407) 585-7000 http://www.Superchips.com
Superchip & Superchips are registered trademarks of Superchips, Inc.
Section A – Overview of
FLASHPAQ
6. Quick Start – Program my vehicle with User Options NOW!!!
Please follow the steps below to program your vehicle
From the opening screen
*** Press DOWN to scroll as needed ***
1) Press ENTER – selects Performance Tuning
2) Press ENTER – selects Read Vehicle
3) Press ENTER – selects Read Stock
4) Follow ON SCREEN Prompts including Vehicle Ignition
ON/OFF requests (DO NOT START VEHICLE!!!)
5) Press EXIT – returns you to previous screen
From this screen
1) Press ENTER – selects Change Setup
2) Press ENTER – selects Power Level
3) Press SAVE – after selection of the tuning level
4) Press ENTER – selects Options
5) Press NEXT/SAVE – adjusts/Saves Rev Limiter (6.0L)
6) Press NEXT/SAVE – adjusts/Saves Speed Limiter
You must have Z rated tires to modify the Speed Limiter
7) Press NEXT/SAVE – adjusts/Saves Tire Height
8) Press EXIT – returns you back one screen
From this screen
1) Press ENTER – after selecting Program Vehicle
2) Follow ON SCREEN Prompts including Vehicle Ignition
ON/OFF requests (DO NOT START VEHICLE!!!)
Upon completion, remove cable from vehicle
Your vehicle is now programmed with Superchips and user options!
You may now start your vehicle.
Page 10 of 24 Form 0157G 1805 10/02/2007
Superchips Inc.
Superchips Inc. 1790 East Airport Blvd., Sanford, FL. 32773 (407) 585-7000 http://www.Superchips.com
Superchip & Superchips are registered trademarks of Superchips, Inc.
Section A – Overview of
FLASHPAQ
7. Quick Start – Return my vehicle to factory stock NOW!!!
Please follow the steps below to program your vehicle
From the opening screen
*** Press DOWN to scroll as needed ***
1) Press ENTER – selects Performance Tuning
2) Press ENTER – selects Change Setup
3) Press ENTER – selects Power Level
4) Press SAVE – after selecting the Stock tuning level
5) Press EXIT – returns you to previous screen
From this screen
1) Press ENTER – after selecting Program Vehicle
2) Follow ON SCREEN Prompts including Vehicle Ignition
ON/OFF requests (DO NOT START VEHICLE!!!)
Upon completion, remove cable from vehicle
Your vehicle’s program is now returned to factory stock. You may now
start your vehicle.
To Next Page
Loading...
