Superchips Flashpaq - Tuning Levels Explained

Page 9 of 24 Form 0158E 3805 07/14/2008 Superchips Inc
.
Superchips Inc. 1790 East Airport Blvd., Sanford, FL. 32773 (407) 585-7000 http://www.Superchips.com
Superchip & Superchips are registered trademarks of Superchips, Inc.
Section A – Overview of
FLASHPAQ
FLASHPAQFLASHPAQ
FLASHPAQ
6. Quick Start – Program my vehicle with User Options NOW!!!
Please follow the steps below to program your vehicle
 From the opening screen
*** Press DOWN to scroll as needed ***
1) Press ENTER – after selection Performance Tuning
2) Press ENTER – after selection of Read Vehicle
3) Press ENTER – after selection of Read Stock
4) Follow ON SCREEN – Prompts including Vehicle Ignition
ON requests (DO NOT START VEHICLE!!)
5) Press EXIT – after Vehicle Read Completed
6) Press ENTER – after selection of Change Setup
7) Press ENTER – after selection of Power Level
8) Press ENTER – after selection of Performance or Tow
9) Press ENTER – after selection of Options
10) Press ENTER – after selection of Tire Size
11) Press PLUS/MINUS & SAVE – adjusts Tire Size Height
12) Press ENTER – selects Program Vehicle
13) Follow ON SCREEN – Prompts including Vehicle Ignition
OFF/ON/OFF requests (DO NOT START VEHICLE!!)
Upon completion, remove cable from vehicle –
Your vehicle is now programmed with Superchips and user options!
You may now start your vehicle.
Page 10 of 24 Form 0158E 3805 07/14/2008 Superchips Inc
.
Superchips Inc. 1790 East Airport Blvd., Sanford, FL. 32773 (407) 585-7000 http://www.Superchips.com
Superchip & Superchips are registered trademarks of Superchips, Inc.
Section A – Overview of
FLASHPAQ
FLASHPAQFLASHPAQ
FLASHPAQ
7. Quick Start – Return my vehicle to factory stock NOW!!!
Please follow the steps below to program your vehicle
 From the opening screen
*** Press DOWN to scroll as needed ***
1) Press ENTER – after selection of Performance Tuning
2) Press ENTER – after selection of Change Setup
3) Follow ON SCREEN – Prompts including Vehicle Ignition
ON requests (DO NOT START VEHICLE!!)
4) Press ENTER – selects Power Level
5) Press ENTER – after selection of Stock
6) Press OK – to set to Stock
7) Press ENTER – selects Program Vehicle
8) Follow ON SCREEN – Prompts including Vehicle Ignition
OFF/ON/OFF requests (DO NOT START VEHICLE!!)
Upon completion, remove cable from vehicle –
Your vehicle’s program is now returned to factory stock. You may
now start your vehicle.