3
2.0 Safety Guidelines
Refer to Manual
• Read and understand manual before operation.
• Failure to understand manual may result in personal injury and/or death.
Wear Eye and Hearing Protection
• Rotating components could cause ying debris.
• Noise levels can reach up to 85 decibels (dB) or above during machine operation.
Warning
• General warning label.
• Indicates an imminent hazard.
Entanglement Hazard
• Keep hands and arms free of rotating shaft.
• Ensure system has stopped and starting has been disabled prior to servicing.
• Do not operate without all guards and covers in place.
Electric Shock
• Exercise caution when working on or nearby. Make certain that power has been disconnected
and all residual voltage has been taken under consideration. Unqualied personnel should
never attempt electrical work.
Contact SuperFlow if you have any questions about the safe operations of our equipment and for service
and advice.
The following universal warning decals can be found in the appropriate locations on your equipment. A
description of each warning decal is provided below. In addition, these symbols will appear throughout the
manual in sections where these hazards may be encountered.
This manual places safety concerns into four categories, they are:
This is the highest level statement. Failure to
follow the listed instructions will most likely result
in severe injury or death.
!
DANGER
The statements used with this level of warning deal
with a safe operating procedure. If they are ignored
the possibility of equipment damage or personal
injury may exist.
!
CAUTION
This is a statement of serious hazard. Failure
to follow the listed instructions could place the
individual at risk of serious injury or death.
!
WARNING
NOTICE indicates precautions relating to operation
or usage of the machine or highlights important
information on a page.
NOTICE
To Next Page
Loading...