A2SDV-4C/8C-LN8F/LN10PF User's Manual
84
Flow Control
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by buffer overow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits
Parity
Stop Bits
ACPI Settings
ACPI Settings
WHEA Support
Select Enabled to support the Windows Hardware Error Architecture (WHEA) platform and
provide a common infrastructure for the system to handle hardware errors within the Windows
OS environment to reduce system crashes and to enhance system recovery and health
monitoring. The options are Disabled and Enabled.
Headless Support
Select Enabled for the system to function without a keyboard, mouse, or monitor. The options
are Disabled and Enabled.
Trusted Computing (Available when a TPM device is installed
and detected by the BIOS)
*The features from here to Current Status Information are displayed if a TPM 1.2
module is detected:
Security Device Support
If this feature and the TPM jumper on the motherboard are both set to Enabled, onboard
security devices will be enabled for TPM support to enhance data integrity and network
security. Reboot the system for a change on this setting to take effect. The options are Disable
and Enable.
TPM State
Select Enabled to use TPM (Trusted Platform Module) settings to enhance system data
security. Reboot your system for any change on the TPM state to take effect. The options
are Disable and Enable.
To Next Page
Loading...
