Supermicro A2SDV-4C-LN8F - Quick Reference Table

15
Chapter 1: Introduction
Note: Table is continued on the next page.
Quick Reference Table
Jumper Description Default Setting
JBR1 BIOS Recovery Pins 1-2 (Normal)
JBT1 CMOS Clear Open (Normal)
JI
2
C1, JI
2
C2 SMB to PCI-E Slots Enable/Disable Pins 2-3 (Disabled)
JPG1 Onboard VGA Enable/Disable Pins 1-2 (Enabled)
JPL1 LAN1 SFP Port Enable/Disable (LN10PF only) Pins 1-2 (Enabled)
JPL2 LAN2 SFP Port Enable/Disable (LN10PF only) Pins 1-2 (Enabled)
JPL3 LN8F: LAN1-4 Ports Enable/Disable
LN10PF: LAN3-6 Ports Enable/Disable
Pins 1-2 (Enabled)
JPL4 LN8F: LAN5-8 Ports Enable/Disable
LN10PF: LAN7-10 Ports Enable/Disable
Pins 1-2 (Enabled)
JPME2 ME Manufacturing Mode Pins 1-2 (Normal)
JSEL1 PCI-E Slot 6/7 Selection Pins 1-2: Slot 7
JWD1 Watch Dog Timer Pins 1-2 (Reset)
LED Description Status
LED1 Power LED Solid Green: Power On
LEDM1 BMC Heartbeat Blinking Green: BMC Normal
UIDLED1 UID LED Solid Blue: Unit Identied
Connector Description
BT1 Onboard Battery
COM1 COM Header
FAN1 - FAN3, FANA, FANB CPU/System Fan Headers
IPMI LAN IPMI LAN Port
I-SATA0-4 SATA 3.0 Ports (SATA3/4 on -8C-LN8F/LN10PF SKUs Only)
(-4C-LN10PF: SATA1/2 are disabled when SLOT6/SLOT7 set to PCI-E 3.0 x2 in the
BIOS.)
JD1 Speaker (Pins 1-4)
JF1 Front Control Panel Header
JFPCLED1 RJ45 LAN LED Board Cable Connector for FPB-FPE300-LED10
JGP1 General Purpose I/O Header
JIPMB1 System Management Bus Header (for IPMI card)
JL1 Chassis Intrusion Header
JLANLED1 LAN3-6 Activity LED
JLANLED2 LAN7-8 Activity LED
JLANLED3 LAN9-10 Activity LED (-LN10PF SKUs Only)
JMD1 M.2 B-Key PCI-E3.0/SATA3.0/USB3.0 Slot