Supermicro H13SAE-MF - Memory Support; DIMM Memory Installation

ContaCt InformatIon
• www.supermicro.com (Email: support@supermicro.com)
• Manuals: http://www.supermicro.com/support/manuals
• Drivers & Utilities: https://www.supermicro.com/wdl/
• Safety: http://www.supermicro.com/about/policies/safety_information.cfm
Memory Population Guidelines
There is no specic order or sequence required when installing memory modules.
However do keep the following in mind:
• The motherboard supports up to 192GB of memory with speeds of up to 5200MT/s (2DPC)
and 3600MT/s (1DPC).
• To achieve the best memory performance, fully populate the motherboard with validated
memory modules and follow the recommended memory population rules and refer to the
table below.
DIMM Memory Installation
Memory Support
The H13SAE-MF motherboard supports up to 192 GB of ECC/Non ECC UDIMM DDR5
5200/4800/3600 MT/s speed, populated in four DIMM slots. Refer to the table below for
additional memory information.
Notes:
• Always use DDR5 DIMM modules of the same type, size and speed.
• For memory optimization, use only DIMM modules that have been validated by Supermicro.
For the latest memory updates, please refer to our website at http://www.supermicro.com/
products/motherboard.
• Please be aware that removing a DDR5 DIMM module at a slant angle may cause dam-
ages. It is recommend that you lift the module straight up out of the slot.
• The DDR5 DIMM module is NOT hot-swappable and be sure to disconnect power for a
minimum of twenty seconds before inserting or removing it.
DIMM Population Guide
Type
Channel
A1 A2 B1 B2
1 DIMM
V
2 DIMMs
V V
4 DIMMs
V V V V
CPU
DIMMB1 DIMMB2 DIMMA1 DIMMA2