MNL-2627-QRG-100
© 2023 Supermicro Computer Inc. All rights reserved. Reproduction of this document whether in part or in whole is strictly prohibited without Supermicro's
written consent. All Trademarks are property of their respective entities. All information provided is deemed accurate at the time of printing; however, it is
not guaranteed.
Notes
• Graphics shown in this quick reference guide are for illustration purposes only. Your compo-
nents may or may not look exactly the same as the drawings shown in this guide.
• Refer to Chapter 2 of the User Manual for detailed information on jumpers, connectors, LED
indicators, memory support and CPU/motherboard installation instructions.
Front Control Panel (JF1)
Rear I/O Ports
# Description # Description # Description
1 Center/LFE Out 8 VGA Port 15 USB 3.2 Gen2 Type A (10 Gb)
2 Surround Out 9 DisplayPort 1.4a 16 USB 3.2 Gen2 Alt Mode*
3 S/PDIF Out 10 HDMI 2.0 Port 17 Dedicated IPMI LAN Port (1 Gb)
4 Line In 11 1 Gb RJ45 Port 18 USB 3.2 Gen2 Type A (10 Gb)
5 Line Out 12 USB 3.2 Gen2 Type A (10 Gb) 19 USB 3.2 Gen2x2 (20 Gb)
6 Mic In 13 USB 3.2 Gen2 Alt Mode* 20 UID
7 COM Port 14 1 Gb RJ45 Port 21 JUBUD1
1
4
7
10
20 21
11
12
2
5
8
3
6
9
13 16 19
14 17
15 18
Back Panel I/O Connectors
*Video out only supports one output at the same time, and it must use Type C to DP
(standard) cable.
UID LED-
1
NIC1 Link LED-
Key, no pinKey, no pin
2
HDD LED-
PWR_LED-
Ground
Ground
Ground
19 20
Power Fail LED+
Reset Switch
Power Fail LED-
NIC2 Link LED-
UID LED+
NIC1 Link LED+
HDD LED+/UID Switch+
PWR LED+
NMI Switch
NIC2 Link LED+
Power Switch
To Previous Page
Loading...
