Supermicro M11SDV-8C-LN4F - Quick Reference Table

15
Chapter 1: Introduction
Quick Reference Table
Jumper Description Default Setting
JBM1 Disable Share LAN Pin 1-2 Open (Enable)
JBM2 Disable IPMI/Share LAN Pin 1-2 Open (Enable)
JBT1 CMOS Clear Open: Normal, Closed: Clear CMOS
JI
2
C1, JI
2
C2 SMB to PCI-E Slots Enable/Disable Pins 2-3 (Disabled)
JPG1 Onboard VGA Enable/Disable Pins 1-2 (Enabled)
JVRM1 VRM SMB Clock (to BMC or PCH) Pins 1-2 (Normal)
JVRM2 VRM SMB Data (to BMC or PCH) Pins 1-2 (Normal)
JWD1 Watch Dog Timer Pins 1-2 (Reset)
LED Description Status
LED1 UID LED Solid Blue: Unit Identied
LED2 Overheat (OH)/PWR Fail/Fan Fail LED
Solid Red: Overheat
Blinking Red: PWR Fail or Fan Fail
LED3 Power LED Solid Green: Power On
LEDM1 BMC Heartbeat Blinking Green: BMC Normal
Connector Description
BT1 Onboard Battery
COM1 RS232 COM Port Header
FAN1 - FAN2, FANA CPU/System Fan Headers
IPMI_LAN Dedicated IPMI LAN Port
JD1 Pins 1-2: PWR LED, Pin 4-7: Speaker
JF1 Front Control Panel Header
JGP1 8-bit General Purpose I/O Header
JMD2 M.2 Slot 2280 M-key (PCIe x 4/SATA 3.0)
JPCIE1 PCI-E 3.0 x 16 Slot
JPI
2
C1 Power I
2
C System Management Bus (Power SMB) Header
JPV1 8-pin 12V DC Power Input (Required for 12V only or 24-pin ATX power)
JSMB System Management Bus Header
JSTBY1 Standby Power Connector
JTPM1 Trusted Platform Module (TPM)/Port 80 Connector
LAN1 - LAN4 1 GbE LAN (RJ45) Ports
PJ1 Header for ATX Power Signal 5VSTBY/Power ON/Power Good/Ground; 24pin ATX to
4pin power cable for PJ1 (Supermicro P/N: CBL-PWEX-1063)
SATA0 - SATA3 SATA 3.0 Ports
UID Unit Identier Switch
USB0-5 USB 2.0 Header
USB6/7 Back Panel USB 3.0 Ports
VGA VGA Port (back panel)