4-5
Chapter 4: MicroBlade Module Features
Figure 4-4. Intel B1SD2-TF Block Diagram
Jumpers
Any jumpers present on the mainboard are used by the manufacturer only; there are no
jumpers used to configure the operation of the mainboard by the user.
CMOS Clear
JBT1 is used to clear CMOS and will also clear any passwords. JBT1 consists of two
contact pads located near the BIOS chip.
Clearing CMOS
1. First power down the blade and remove it from the enclosure.
2. Short the CMOS pads with a metal object such as a small screwdriver.
3. Install the blade back into the enclosure and power it on.
Table 4-4. B1SD2-TF Mainboard Layout
Item Description
1 One Intel Xeon D-1541 processor embedded in a FCBGA 1667 socket
2 One SATA3 SATA-DOM connector
3 Eight DIMM slots for DIMM memory modules
5 CMOS Clear
To Next Page
Loading...
