B-4
SUPERSERVER 6028U-T Series User's Manual
6. After the process of BIOS recovery is completed, press any key to reboot the
system.
7.
drive.
8. When a DOS prompt appears, enter FLASH.BAT BIOSname.### at the prompt.
Note: Do not interrupt this process
9. After seeing the message that BIOS update is completed, unplug the AC power
cable from the power supply to clear the CMOS, and then plug the AC power
cable in the power supply again to power on the system.
10. Press <Del> continuously to enter the BIOS Setup utility.
11. Press <F3> to load default settings.
12. After loading default settings, press <F4> to save the settings and exit the BIOS
Setup utility.
To Next Page
Loading...
