Supermicro SuperServer 6028U-TR4+ - Control Panel Buttons; Control Panel Leds

SuperServer 6028U-T Series User's Manual
3-2
3-3 Control Panel LEDs
There are six LEDs that provide status information about the system.
Power: The main power switch is used to apply or remove power from the power
󰀨
main power but keeps standby power supplied to the system. Therefore, you must
unplug system before servicing.
Reset: The reset button is used to reboot the system.
3-2 Control Panel Buttons
The chassis includes two push-buttons that control power to the system.
Power: Indicates power is being supplied to the system power supply units. This
LED should normally be illuminated when the system is operating.
HDD
NIC2
2