Supermicro SuperServer 6028U-TR4+ - Page 62

5-18
SUPERSERVER 6028U-T Series User's Manual
DOM Power Connectors
Two power connectors for SATA
DOM (Disk On Module) devices are
located at JSD1 and JSD2. These
connectors are used with Supermciro
SuperDOMs to provide backward-
compatible power support to non-
Supermicro SATADOMs that require
external power supply.
DOM PWR
Pin Denitions

1 +5V
2 Ground
3 Ground
I-SGPIO2 Header
A Serial-Link General Purpose Input/
Output header (I-SGPIO2) supports
onboard I-SATA 4/5. See the table on

I-SGPIO
Pin Denitions
 
1 NC 2 NC
3 Ground 4 Data
5 Load 6 Ground
7 Clock 8 N
NC = No Connection
Unit Identier Buttons/UID LED
Indicators
     
is located next to the COM port. The
connection for the front UID button
is located on pin 13 of JF1. The rear
UID LED (LED1) is located next to the
rear UID button, and the front UID LED
connection is located on pin 7 of JF1.
When you press the rear UID button,
both front and rear UID LED indicators
will be turned on. Press the UID button
   󰀨    
   
of a system unit that may be in need
of service.
Note: UID can also be triggered via
IPMI. For more information on IPMI,
please refer to the IPMI User's Guide
posted on our website.
UID Button

1 Ground
2 Ground
3 Button In
4 Button In
UID LED
Status
Color/State Status
Blue: On 