Chapter 5: Advanced Serverboard Setup
5-21
VGA Enable/Disable
JPG1 allows you to enable or disable
the onboard VGA port. The default
position is on pins 1 and 2 to enable
VGA. See the table on the right for
jumper settings. The default setting
is enabled.
VGA Enable/Disable
Jumper Settings
Pins 1-2 Enabled
Pins 2-3 Disabled
ME Manufacturing Mode Select
Close pin 2 and pin 3 of jumper
and force the system to operate in
the Manufacturer (ME) mode, allowing
from a host server for system setting
right for jumper settings.
ME Mode Select
Jumper Settings
Pins 1-2 Normal
Pins 2-3 Manufacture Mode
Watch Dog Enable/Disable
JWD1 controls the Watch Dog
function. Watch Dog is a system
monitor that can reboot the system
when a software application “hangs”.
Pins 1-2 will cause WD to reset the
system if an application hangs. Pins
2-3 will generate a non-maskable
interrupt signal for the application that
has hung. See the table on the right
for jumper settings. Watch Dog must
also be enabled in BIOS.
Watch Dog
Jumper Settings
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
BMC Enable
Jumper JPB1 allows you to enable the
embedded onboard BMC (Baseboard
Management) controller to provide
IPMI 2.0 support on the serverboard.
See the table on the right for jumper
settings.
BMC Enable
Jumper Settings
Pins 1-2 BMC Enable
Pins 2-3 Normal
To Next Page
Loading...
