Supermicro X11DPX-T - Page 44

44
Super X11DPX-T User's Manual
LAN
CTRL
DESIGNED IN USA
X11DPX-T
REV:1.01A
CPU2
CPU1
BIOS
LICENSE
SAN MAC
MAC CODE
BAR CODE
PCH
IPMI CODE
BMC
1. UID
2. IPMI_LAN
3. Front UID LED
4. LED2
2
1
2
Unit Identier Switch/UID LED Indicator
A rear Unit Identier (UID) switch (JUIDB1) and an rear LED Indicator (LED2) are located
on the rear side of the system. The front UID LED is located on Pin 7 of the Front Control
Panel (JF1). When you press the UID switch, both front and rear UID LED indicators will be
turned on. Press the UID switch again to turn o󰀨 the LEDs. The UID Indicators provide easy
identication of a system unit that may be in need of service.
Note: UID can also be triggered via IPMI on the motherboard. For more information
on IPMI, please refer to the IPMI User's Guide posted on our website at http://www.
supermicro.com.
UID Switch
Pin Denitions
Pin# Denition
1 Ground
2 Ground
3 Button In
4 Button In
UID LED
Pin Denitions
Color Status
Blue: On Unit Identied
IPMI LAN Port
An IPMI_Dedicated LAN that supports Gigabit LAN is located next to USB ports 0/1 on the
back panel. This LAN port is supported by the onboard AST2500 BMC and accepts an RJ45
type cable. Refer to the LED Indicator Section for LAN LED information.
UID LED
NIC1 Active LED
HDD LED
PWR LED
3.3V Stby
3.3V Stby
Ground
19
Ground
3.3V Stby
20
1 2
Ground
Power Fail LED
NIC2 Active LED
NMI
3.3V
3.3V
OH/PWR Fail/Fan Fail LED
Power Button
Reset Button
x
x
3
4
LAN Ports
Pin Denitions
Pin# Denition Pin# Denition
1 P2V5SB 10 SGND
2 TD0+ 11 Act LED
3 TD0- 12 P3V3SB
4
TD1+
13
Link 100 LED (Yellow,
+3V3SB)
5
TD1-
14
Link 1000 LED (Yel-
low, +3V3SB)
6 TD2+ 15 Ground
7 TD2- 16 Ground
8 TD3+ 17 Ground
9 TD3- 18 Ground