Supermicro X11SAE-M - Page 51

51
Chapter 2: Installation
MAC CODE
BIOS
LICENSE
DESIGNED IN USA
X11SAE-M
REV: 1.01
BAR CODE
S1
BIOS RESTORE
JF1
JPW2
JPW1
SP1
B3
JD1
JBT1
JTBT1
JSD1
JTPM1
JL1
JSTBY1
COM1
I-SATA3 I-SATA2
I-SATA7
I-SATA6
I-SATA1
I-SATA5
I-SATA0
I-SATA4
I-SGPIO1
I-SGPIO2
J23
LED3
LED1
FAN2
FAN1
FAN4
FAN5
JPME2
JPAC1
JWD1
JI2C1 JI2C2
JLED1
JPL2
JPL1
JVR1
MH12
MH9
MH10
MH11
FAN3
PCH
C236
SIO
BIOS
USB8/9(3.0)
USB10/11(3.0)
USB2/3 USB4/5
AUDIO FP
SLOT5 PCI 33MHz
PCH SLOT4 PCI-E 3.0 X4
CPU SLOT7 PCI-E 3.0 X16
HD AUDIO
UNB ECC/NON-ECC DDR4 DIMM REQUIRED
ALWAYS POPULATE BLUE SOCKET FIRST
M.2 PCI-E 3.0 X4
USB0/1
LAN2
USB6/7(3.0)
LAN1
HDMI/DP
DVI-D
DIMMB2
DIMMB1
DIMMA2
DIMMA1
CPU FAN
USB12/13(3.1)
CPU Socket LGA 1151
1
2
SMBus to PCI Slots
Jumpers JI
2
C1 and JI
2
C2 allow you to connect the System Management Bus (I
2
C) to the
PCI-E/PCI slots. The default setting is Open (Disabled.) Both jumpers must be set to the same
setting (JI
2
C1 controls the clock and JI
2
C2 controls the data). The default setting is Disabled.
SMBus to PCI Slots
Jumper Settings
JI
2
C1 Setting JI
2
C2 Setting Denition
JI
2
C1: Pins 1-2 JI
2
C2: Pins 1-2 Enabled
JI
2
C1: Pins 2-3
JI
2
C2: Pins 2-3 Disabled
1. SMBus to PCI Slots
2. Manufacturing Mode
ME Manufacturing Mode Select
Close JPME2 to bypass SPI ash security and force the system to use the ME Manufacturing
Mode, which will allow you to ash the system rmware from a host server to modify system
settings. Refer to the table below for jumper settings.
ME Manufacturing Mode
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode