Supermicro X11SCM-LN8F - Page 51

51
Chapter 2: Installation
1. Onboard Buzzer
2. Speaker Header
IPMI CODE
+
+
X11SCL-LN4F
REV:1.00
MAC CODE
BAR CODE
DESIGNED IN USA
BIOS LICENSE
LAN4/8
LAN3/7
LAN2/6
LAN1/5
JPL4
JPL8
JPL3
JPL7
JPL2
JPL6
JPL1
JPL5
FAN4
COM1
IPMI_LAN
USB0/1
USB4/5
(3.0)
VGA
JLD2
JLD1
JPW2
JPW1
FAN2
FAN1
LED_PWR_SB
X11SCM-LN8F/-F
Intel
C246 / C242
2280
22110
2280
BMC_HB_LED
LED4
JUIDB1
JWD1
JPME2
JPG1
JBAT1
SP1
USB2/3
JTPM1
I-SGPIO1
I-SGPIO2
JBT1
I-SATA3
I-SATA2
I-SATA1
I-SATA0
I-SATA5
I-SATA4
JL1
FANB
FANA
JSD2JSD1
JSTBY1
USB8
(3.0)
JLED1
JF1
FAN3
PWR_LED
ASpeed
AST2500
M.2-P_1
M.2-H_2
JD1
USB6/7 (3.0)
CPU
DIMMA1
DIMMA2
DIMMB1
DIMMB2
22110
NMI
JF1
LED
PWR
X
LED
HDD
NIC
LED
UID
2
NIC
1
RST
PWR
ON
FAIL
PS
CPU SLOT6 PCI-E 3.0 X16
Intel
i210
Intel
i210
1
Speaker Header
JD1 is used to connect an extra speaker. By default, pins 3-4 are closed with a cap to enable
the onboard buzzer at SP1. To use an extra speaker instead, connect the speaker connector
to pins 1-4. Refer to the table below for pin denitions.
Speaker/Onboard Buzzer Header
Pin Denitions
Pin# Signal
1 P5V
2 Key
3 R_SPKPIN_N
4 R_SPKPIN
Onboard Buzzer
The Onboard Buzzer located at SP1 is used to provide audible indicators for various beep
codes. By default, pins 3-4 of JD1 are closed with a cap, which enables the use of this buzzer.
Refer to the table below for pin denitions.
2
Onboard Buzzer
Pin Denitions
Pin# Denition
1 Pos (+) VCC
2 Neg (-) Beep In