Supermicro X11SCQ-L - Page 55

55
Chapter 2: Installation
+
X11SCQ
REV:1.01
MAC CODE
BAR CODE
DESIGNED IN USA
BIOS
LICENSE
Intel
Q370/H310
JGP1
JSMB1
DIMMA1
DIMMB1
DIMMA2
DIMMB2
J23
COM3/4
COM5/6
MH12
MH11
MH9
CON1
JPW2
SP1
COM2
COM1
JSTBY1
JD1
FAN1
FAN3
FAN4
FAN2
JPT1
JAT1
JPME2
JWD1
JLED1
JPL2
JPAC1
JPL1
JPW1
JL1
I-SATA5
I-SATA2
I-SATA4
I-SATA1
I-SATA3
I-SATA0
JF1
JBT1
JSD1
JTPM1
J*
B3
LED3
LED1
EDP
CPU
AUDIO FP
USB4/5
USB6/7(3.1)
SLOT4
SLOT5
SLOT6
ON
PWR
X
LED
OH/FF
RST
NIC2 NIC1
HDD
LED
USB10/11(3.1)
LED
PWR
HD AUDIO
SLOT7
UNB NON-ECC DDR4 DIMM REQUIRED
ALWAYS POPULATE BLUE SOCKET FIRST
PCI-E M.2-M1
LAN2
USB2/3
USB8/9(3.1)
LAN1
HDMI/DP
DVI-D
CPU FAN
KB/MOUSE
USB0/1
J5
2
Onboard TPM2.0 Enable/Disable (X11SCQ only)
Use JPT1 to enable or disable support for the onboard TPM 2.0 module. This jumper is not
available on the X11SCQ-L. The default setting is Enabled.
TPM Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the
system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt
signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default
setting is Reset.
Note: When Watch Dog is enabled, users need to write their own application software
to disable it.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset (Default)
Pins 2-3 NMI
Open Disabled
1. Watch Dog Timer
2. TPM Enable
1