Supermicro X11SCV-Q - Page 76

Super X11SCV-Q/-L User's Manual
76
PEG Port Conguration
CPU1 SLOT7 PCI-E 3.0 X16 OPROM
SLOT7 Enable Root Port
Use this feature to enable or disable the PCI Express Graphics (PEG) device in the port
specied by the user. The options are Disable, Enable, and Auto.
SLOT7 Max Link Speed
Use this feature to select PCI-E support for the device installed on SLOT7. The options
are Auto, Gen 1, Gen 2, and Gen 3.
SLOT7 Power Limit Value
Use this feature to set the upper limit on the power supplied by the PCIE slot. Press "+"
or "-" on your keyboard to change this value. The default setting is 75.
SLOT7 Slot Power Limit Scale
Use this feature to select the scale used for the slot power limit value. The options are
1.0x, 0.1x, 0.01x, and 0.001x.
Program PCIe ASPM After OpROM
PCIe ASPM, the Active State Power Management for PCI-Express slots, is a power
management protocol used to manage power consumption of serial link devices installed
on PCI-E slots during a prolonged off-peak time. If this feature is set to Enabled, PCI-E
ASMP will be programmed after OPROM. If set to Disabled, the PCI-E ASPM will be
programmed before OPROM. The options are Disabled and Enabled.
GT - Power Management Control
RC6 (Render Standby)
Use this feature to enable render standby support. The options are Disabled and En-
abled.
Maximum GT frequency
Use this feature to dene the Maximum GT frequency. Choose between 33MHz (RPN)
and 1200Mhz (RP0). Any value beyond this range will be clipped to its min/max sup-
ported by the CPU. The options are Default Max Frequency, 100Mhz, 150MHz,
200MHz, 250MHz, 300MHz, 350MHz, 400MHz, 450MHz, 500MHz, 550MHz, 600MHz,
650MHz, 700MHz, 750MHz, 800MHz, 850MHz, 900MHz, 950MHz, 1000MHz, 1050MHz,
1100MHz, 1150MHz, and 1200MHz.