Supermicro X11SCW-F - Page 87

Chapter 4: BIOS
87
Above 4GB MMIO BIOS Assignment
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Enable and Disabled.
SR-IOV Support
Use this feature to enable or disable Single Root IO Virtualization support. The options are
Disabled and Enabled.
VGA Priority
Use this feature to select VGA priority when multiple VGA devices are detected. Select On-
board to give priority to your onboard video device. Select Offboard to give priority to your
graphics card. The options are Onboard and Offboard.
NVMe Firmware Source
Use this feature to select the NVMe rmware to support booting. The options are Vendor
DenedFirmware and AMI Native Support. The default option, Vendor Dened Firmware,
is pre-installed on the drive and may resolve errata or enable innovative functions for the
drive. The other option, AMI Native Support, is offered by the BIOS with a generic method.
PCIe/PCI/PnPConguration
RSC-W-68 SLOT1 PCI-E 3.0 x16 OPROM / RSC-W-68 SLOT2 PCI-E 3.0 x8 OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot.
The options are Disabled, Legacy, and EFI.
RSC-R1UW-E8R SLOT1 PCI-E x8 OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot.
The options are Disabled, Legacy, and EFI.
M.2-H_1 / M.2-P_2 OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot.
The options are Disabled, Legacy, and EFI.
Onboard LAN Option ROM Type
Use this feature to select which rmware type to be loaded for onboard LAN ports. The
options are Legacy and EFI.
*If the feature above is set to Legacy, the following LAN ports will be listed and become
available for conguration:
Onboard LAN1 ~ LAN2 Option ROM
Use this feature to select which rmware function to be loaded for the specied onboard LAN
port at system boot. The options are Disabled, PXE, and iSCSI*.