Supermicro X11SSE-F - Page 39

39
Chapter 2: Installation
2
CMOS Clear
JBT1 is used to clear the CMOS. Instead of pins, this "jumper" consists of contact pads to
prevent accidental clearing of the CMOS. To clear the CMOS, use a metal object such as a
small screwdriver to touch both pads at the same time to short the connection.
Note: Be sure to completely shut down the system, and then short JBT1 to clear the
CMOS.
VGA Enable/Disable
Jumper JPG1 allows the user to enable the onboard VGA connector. The default setting is
pins 1-2 to enable the connection. Refer to the table below for jumper settings.The default
setting is Enabled.
VGA Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled
Pins 2-3 Disabled
BMC
Intel PCH
CPU
USB2 (3.0)
I-SATA6
JSD1
SW2
LED5 JUIDB1
LED6
MAC CODE
BAR CODE
BIOS
LICENSE
JPG1
JKVM1/VGA
USB0/1
BT1
JWD1
JPME2 JPME1
JTPM1
JBT1
CPU MICRO-LP PCI-E 3.0 X8
JPO1
J21
MICRO-LP
DIMMB2 DIMMB1 DIMMA2 DIMMA1
I-SATA0
X11SSE-F
Rev. 1.01
1. CMOS Clear
2. VGA Enable
1