40
X11SSE-F User Manual
Watch Dog
Watch Dog (JWD1) is a system monitor that can reboot the system when a software
application hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3
to generate a non-maskable interrupt (NMI) signal for the application that hangs. Refer to the
table below for jumper settings. The Watch Dog must also be enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
Management Engine (ME) Recovery
Use jumper JPME1 to select ME Firmware Recovery mode, which will limit resource
allocation for essential system operation only in order to maintain normal power operation
and management. In the single operation mode, online upgrade will be available via Recovery
mode. Refer to the table below for jumper settings.
Manufacturer Mode
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal
Pins 2-3 ME Recovery
BMC
Intel PCH
CPU
USB2 (3.0)
I-SATA6
JSD1
SW2
LED5
JUIDB1
LED6
MAC CODE
BAR CODE
BIOS
LICENSE
JPG1
JKVM1/VGA
USB0/1
BT1
JWD1
JPME2
JPME1
JTPM1
JBT1
CPU MICRO-LP PCI-E 3.0 X8
JPO1
J21
MICRO-LP
DIMMB2
DIMMB1
DIMMA2
DIMMA1
I-SATA0
X11SSE-F
Rev. 1.01
2
1
1. Watch Dog
2. ME Firmware Recovery
To Next Page
Loading...
