Supermicro X11SSE-F - Page 42

42
X11SSE-F User Manual
Power Fail Override
JPO1 is the power-failure override jumper. Close pin 1 and pin 2 of this jumper to override
the power operations policy set by the manufacturer, and allow the remaining functional
power supply to run at full capacity instead of operating at normal “power-safe” state as
recommended by the manufacturer in the event of a power supply failure. Refer to the table
below for jumper settings. The default setting is Disabled.
Note: Please use this jumper with caution. Enabling this jumper may cause the remain-
ing power supply to run out unexpectedly and your motherboard to shut down.
Title
Pin Denitions
Jumper Setting Denition
Pins 1-2 Override power
Pins 2-3 Disabled
BMC
Intel PCH
CPU
USB2 (3.0)
I-SATA6
JSD1
SW2
LED5 JUIDB1
LED6
MAC CODE
BAR CODE
BIOS
LICENSE
JPG1
JKVM1/VGA
USB0/1
BT1
JWD1
JPME2 JPME1
JTPM1
JBT1
CPU MICRO-LP PCI-E 3.0 X8
JPO1
J21
MICRO-LP
DIMMB2 DIMMB1 DIMMA2 DIMMA1
I-SATA0
X11SSE-F
Rev. 1.01
1
1. Power Fail Override