X11SSH-F/-LN4F User Manual
88
SATA Mode Selection
Use this item to select the mode for the installed SATA drives. The options are AHCI and RAID.
SATA Frozen
Use this item to enable the HDD Security Frozen Mode. The options are Enabled and
Disabled.
*If the item above "Congure SATA as" is set to AHCI, the following items will display:
SATA Port 0~ Port 7
This item displays the information detected on the installed SATA drive on the particular
SATA port.
Port 0~ Port 7
The status of a SATA port will be displayed as detected by the BIOS.
Port 0 ~ Port 7 Software Preserve
The status of software preserve of a SATA port will display as it is detected by the BIOS.
Port 0 ~ Port 7 Hot Plug
This feature designates the port specied for hot plugging. Set this item to Enabled for hot-
plugging support, which will allow the user to replace a SATA disk drive without shutting
down the system. The options are Enabled and Disabled.
Port 0 ~ Port 7 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Enabled and Disabled.
Port 0 ~ Port 7 SATA Device Type
Use this item to specify if the SATA port specied by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
*If the item above "SATA Mode Selection" is set to RAID, the following items will
display:
SATA RAID Option ROM/UEFI Driver
Select UEFI to load the EFI drvier for system boot. Select Legacy to load a legacy driver
for system boot. The options are Legacy ROM and UEFI Driver.
SATA Frozen
Use this item to enable the HDD Security Frozen Mode. The options are Enabled and
Disabled.
To Next Page
Loading...
Need help?
General
