Supermicro X11SSV-Q - SO-DIMM Installation; SO-DIMM Removal

28
X11SSV-Q User's Manual
SINGLE-LINK
m-PCIE(F/H)
M.2
HD
AUDIO
CPU SLOT1 PCI-E 3.0 X16
PWR
LED
NICHDD
LED
NIC
21
OH/FF
USB11/12
USB7/8
RSTX
PWR
JF1
ON
(3.0)
USB5/6
USB9
COM1/2
DVI-I
DIMMA1
DIMMB1
UNB NON-ECC DDR4 DIMM REQUIRED
LAN2
USB3/4(3.0)
REV:
X11SSV-Q
1.01
USB1/2(3.0)
LAN1
CPU
DESIGNED IN USA
DP
HDMI
MAC CODE
BAR CODE
BIOS
LICENSE
A C
1
JGPIO1
JI2C1
JI2C2
JWD1
JVR1
JPAC1
JPME2
JPUSB1
JSMB1
JD1
JL1
JSD1
JSD2
JTPM1
SRW6
SRW5
I-SATA0
I-SATA1
I-SATA4
I-SATA3
I-SATA2
SRW2
SRW1
JBT1
LED1
JF1
BT1
JPW1
JPW2
JP1
FAN4
FAN2
FAN3
FAN1
J3
I-SGPIO1
SO-DIMM Installation
1. Insert SO-DIMM modules in the following
order: DIMMA1, then DIMMB1. For the
system to work properly, please use
memory modules of the same type and
speed on the motherboard.
2. Position the SO-DIMM module's bottom key
so it aligns with the receptive point on the
slot. Take note of the module's side notches
and the locking clips on the socket.
3. Insert the SO-DIMM module straight down.
4. Press down until the module locks into
place. The side clips will automatically
secure the SO-DIMM module, locking it into
place
Align
SO-DIMM Removal
1. Use your thumbs to gently push the side
clips near both ends away from the module.
This should release it from the slot. Pull the
SO-DIMM module upwards.