Supermicro X11SSV-Q - Amt Configuration

X11SSV-Q User's Manual
78
Serial Port 2
Select Enabled to enable the selected onboard serial port. The options are Enabled and
Disabled.
Logical Device Settings
This item displays the status of a serial part specied by the user.
Serial Port 2 Change Settings
This feature species the base I/O port address and the Interrupt Request address of a
serial port specied by the user. Select Auto to allow the BIOS to automatically assign the
base I/O and IRQ address.
The options for Serial Port 2 are Auto, (IO=2F8h; IRQ=3; DMA), (IO=3F8h; IRQ=3, 4, 5, 6,
7, 9, 10, 11, 12; DMA), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; DMA), (IO=3E8h; IRQ=3,
4, 5, 6, 7, 9, 10, 11, 12; DMA), and (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; DMA).
PCH-FW Conguration
The following rmware information will display:
• ME FW Version
• ME Firmware Mode
• ME Firmware Type
• ME Firmware SKU
ME FW Image Re-Flash
Use this feature to update the Mangement Engine rmware. The options are Enabled and
Disabled.
AMT Conguration
Intel AMT
Select Enabled to use Intel AMT (Active Management Technology) to enhance system
performance. The options are Disabled and Enabled.
BIOS Hotkey Pressed
Select Enabled to use the BIOS Hotkey feature. The options are Disabled and Enabled.
Watch Dog
Select Enabled to allow AMT to reset or power down the system if the operating system or
BIOS hangs or crashes. The options are Disabled and Enabled.