X11SSV-Q User's Manual
72
DMI VC1 Control
Use this feature to enable or disable DMI Virtual Channel 1. The options are Enabled and
Disabled.
DMI VCm Control
Use this feature to enable or disable the DMI Virtual Channel map. The options are Enabled
and Disabled.
DMI Link ASPM Control
Use this feature to set the ASPM (Active State Power Management) state on the SA (System
Agent) side of the DMI Link. The options are Disabled and L1.
DMI Extended Sync Control
Use this feature to enable or disable the DMI extended synchronization. The options are
Enabled and Disabled.
DMI De-Emphasis Control
Use this feature to congure the De-emphasis control on DMI. The options are -6dB and
-3.5dB.
PEG Port Conguration
SLOT1 Max Link Speed
This feature allows the user to select PCI-E support for the device installed on SLOT1. The
options are Auto, Gen 1, Gen 2, and Gen 3.
SLOT1 Max Link Width
Use this feature to set the PCI-E slot to operate as a single X16 slot or to bifurcate into two
X8 slots. A proper riser card must be used to take advantage of bifurcation. The options
are Force X16 and Force X8.
SLOT1 Max Payload Size
Use this feature to select the PEG0 maximum payload size. The options are Auto, 128
TLP, and 256 TLP.
SLOT1 Power Limit Value
Use this feature to set the upper limit on the power supplied by the PCIE slot. Press "+"
or "-" on your keyboard to change this value. The default setting is 75.
SLOT1 Power Limit Scale
Use this feature to select the scale used for the slot power limit value. The options are
1.0x, 0.1x, 0.01x, and 0.001x.
To Next Page
Loading...
