Supermicro X12SCA-F - Page 108

Super X12SAE/X12SCA-F User's Manual
108
*If the Conguration Address Source is set to Static, the following features will
become available for conguration:
Station MAC Address
This feature displays the Station MAC address for this computer. Mac addresses are six
two-digit hexadecimal numbers.
Station IP Address
This feature displays the Station IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This feature displays the sub-network that this computer belongs to. The value of each
three-digit number separated by dots should not exceed 255.
Gateway IP Address
This feature displays the Gateway IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 172.31.0.1).
VLAN
This feature enables the IPMI VLAN function. The options are Disabled and Enabled.
*If the feature above is set to Enabled, the following feature will become available for
conguration:
VLAN ID
Use this feature to enter the VLAN ID. The default setting is 1.
Congure IPv6 Support
IPv6 address status
This section displays status of station IPv6 address to BMC.
IPv6 Support
Use this feature to enable IPv6 support. The options are Enabled and Disabled.
Conguration Address Source
This feature allows the user to select the source of the IP address for this computer. If
Static is selected, you will need to know the IP address of this computer and enter it to the
system manually in the eld. If DHCP is selected, the BIOS will search for a DHCP (Dynamic
Host Conguration Protocol) server in the network that is attached to and request the next
available IP address for this computer. The options are Static and DHCP.