Supermicro X12SCA-F - Installation

34
Super X12SAE/X12SCA-F User's Manual
2.5 M.2 Installation
Two M.2 M key sockets and two form factors are
supported by this motherboard. M.2 sockets are used
for solid state storage and internal expansion. Follow
the steps below in order to install an M.2 device.
1. Loosen the screw from M.2 stando󰀨 (pre-installed). Carefully plug the M.2 device into
the M.2 socket and lower the semi-circle notched end onto the stando󰀨.
2. Tighten the M.2 SSD with the screw removed in
Step 1.
• To install the form factor of M.2 2280, relocate the
stando󰀨 where pre-installed on the 22110 mounting
hole, and then follow the steps above to install the
2280 device.
PCI-E_M.2-M1
PCI-E_M.2-M2
2280
2280
M.2-M2
M.2-M1
22110
22110