Supermicro X12SCA-F - Page 93

Chapter 4: UEFI BIOS
93
COM1 Parity
A parity bit can be sent along with regular data bits to detect data transmission errors.
Select Even if the parity bit is set to 0, and the number of 1's in data bits is even. Select
Odd if the parity bit is set to 0, and the number of 1's in data bits is odd. Select None
if you do not want to send a parity bit with your data bits in transmission. Select Mark
to add a mark as a parity bit to be sent along with the data bits. Select Space to add a
Space as a parity bit to be sent with your data bits. The options are None, Even, Odd,
Mark, and Space.
COM1 Stop Bits
A stop bit indicates the end of a serial data packet. Select 1 Stop Bit for standard serial
data communication. Select 2 Stop Bits if slower devices are used. The options are 1
and 2.
COM1 Flow Control
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None and Hardware RTS/CTS.
COM1 VT-UTF8 Combo Key Support
Check the box to enable VT-UTF8 Combination Key support for ANSI/VT100 terminals.
The options are Unchecked and Checked.
COM1 Recorder Mode
Check the box to capture the data displayed on a terminal and send it as text messages
to a remote server. The options are Unchecked and Checked.
COM1 Resolution 100x31
Check the box to enabled for extended terminal resolution support. The options are
Unchecked and Checked.
COM1 Putty KeyPad
This feature selects the settings for Function Keys and KeyPad used for Putty, which
is a terminal emulator designed for the Windows OS. The options are VT100, LINUX,
XTERMR6, SCO, ESCN, and VT400.
COM1 Legacy OS Redirection Resolution
Use this feature to select the number of rows and columns used in Console Redirection
for legacy OS support. The options are 80x24 and 80x25.