X12SPA-TF QUICK REFERENCE GUIDE M.2 Device Installation
2260 M.2 Device Installation
1. Locate the pre-installed stando and screw (in the position of 2280 mounting hole). Remove
the screw and set it aside.
2. Using a hex socket screwdriver, remove and then re-install the stando to the position of 2260
mounting hole.
3. Insert the M.2 device into the M.2 socket at a 30 degree and press it down.
4. Tighten the screw to secure the M.2 device into place. Do not overtighten so as to avoid dam-
aging the M.2 device.
To Next Page
Loading...
