X12SPA-TF QUICK REFERENCE GUIDE M.2 Device Installation
M.2 Device Installation
This motherboard has four M.2 M-key sockets that support M.2 2260/2280/22110 modules. One
stando and a screw are pre-installed into the position of each 2280 mounting hole; one stando
is pre-installed into the position of each 22110 mounting hole.
Note 1: It is strongly recommended that you install a heatsink on the M.2 device or use a M.2 device
with a built-in heatsink.
Note 2: Be sure to install the M.2 device(s) prior to placing the motherboard into a chassis.
2280/22110 M.2 Device Installation
1. Locate the pre-installed screw (in the position of 2280 mounting hole). Remove the screw and
set it aside.
2. Insert the M.2 device into the M.2 socket at a 30 degree and press it down.
3. Tighten the screw to secure the M.2 device into place. Do not overtighten so as to avoid dam-
aging the M.2 device.
To Next Page
Loading...
