Supermicro X12SPW-TF - Page 105

Chapter 4: BIOS
105
Boot URI
Highlight the feature and press enter to create a boot URI.
Instance of Priority 2:
Use this feature to set the rank target port. The default value is 0.
iSCSI Conguration
Attempt Priority
Attempt Priority
Use this feature to set the attempt priorities. The options are Host Attempt, Redsh Attempt,
and Rsd Attempt.
Commit Changes and Exit
Select this feature to save the changes and exit.
Host iSCSI Conguration
iSCSI Initiator Name
This feature allows you to enter the unique name of the iSCSI Initiator in IQN format. Once
the name of the iSCSI Initiator is entered into the system, congure the proper settings for
the following features.
Add an Attempt
Delete Attempts
Change Attempt Order
Intel(R) Ethernet Controller X550 - xx:xx:xx:xx:xx:xx
Intel(R) Ethernet Controller X550 - xx:xx:xx:xx:xx:xx
NIC Conguration
Link Speed
Use this feature to specify the port speed used for the selected boot protocol. The options
are Auto Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
Select Enabled for wake on LAN support, which allows the system to wake up when an
onboard LAN device receives an incoming signal. The options are Disabled and Enabled.